This version of this app is the first version to support larger drives and will be needed to format and partition drives greater than 128GB.
Mac g3 emulator mac os#
With drives over 128GB, as far as the Mac OS revision, you will be stuck with Mac OS 9.2.2 only, as it contains Apple Drive Setup V2.1. We have tested the following Macs and they can see hard drives of up to 500GB within Mac OS 9.2.2: QuickSilver 733, QuickSilver 800, QuickSilver DP 800, QuickSilver 867, QuickSilver 933, QuickSilver Dual 1 GHz with logic board 820-1342-B (QS logic board 820-1276-A will NOT work and peak out at 128 GB), All FW400 MDD models, Titanium PowerBook 800, Titanium PowerBook 867, Titanium PowerBook 1Ghz will work nicely. Well, it is the ability of the Mac to see the total number of heads, cylinders, and sectors of large hard drives.
What the hell is 48-bit LBA compliant, you ask?
If you intend to use PATA/IDE hard drives larger than 128GB under OS 9, then be aware that you will need the combination of a Mac with an IDE controller that is 48-bit LBA compliant and operating system version 9.2.2 IF YOU ARE GOING TO USE A HARD DRIVE GREATER THAN 128 GB USE Mac OS 9.2.2
Mac g3 emulator update#
MacOS 9.1 Update -> MacOS 9.2.1 Update -> MacOS 9.2.2 Update If your Mac system restore leaves you in the V9.0 realm, it can be patched as follows: So, you are half way there, with only V9.1, V9.2, V9.2.1, and V9.2.2 to consider. You can probably rule out V9.0, V9.02, V9.03, and V9.04 for stability issues and the lack of enhancements. However, I can tell you from personal experience that it is best to do some research after you decide upon your favorite application(s). In general, many users have favored the very last revision, Mac OS 9.2.2 as the most stable and preferred version. Unfortunately, there has always been a heated debate on which Mac OS 9 version to install. It is however $1 cheaper than version 1.1.Below you will find some general background info:
Mac g3 emulator software#
All the firmware and software is identical with the older version of the SCSI2SD project, which fortunately licenses them under GPL, enabling free reuse.
It is possible to purchase PCB only for $8, which should minimise the cost of the drive. I started looking for an alternative and found a competitive project that rebuilt SCSI2SD drive as a kit suitable for home amateur assembly. I think it is a bit too expensive given the large quantity of drives in need and comparable prices of the machines that await resurrection. SCSI2SD costs about $60 for 3.5″ version and $80 for 2.5″ Powerbook edition. The problem is that I have more than 10 machines in need of drive replacement. I have one of those drives and find it reliable. One on the popular modern SCSI drive emulators is SCSI2SD from codesrc. Gotek in an external Amiga drive closure.
0 kommentar(er)
